Toshiba D-KR4SU Manuel d'utilisateur Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 131
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
29
Playback
Recording
Editing
Others
Introduction
Function setup
DVD-RAM physical format
Physical formatting is a simple execution for a disc which
cannot be used or read (or which is becoming hard to
read). It may refresh such a disc for recording and
playback. (There is no guarantee that all such discs will
be recovered.)
“DVD-RAM logical format” process only rewrites certain
data on file system and management information,
however, “DVD-RAM physical format” rewrites all data on
a disc, therefore it takes a much longer time to complete.
For a 4.7GB single sided DVD-RAM, about 70 minutes
will be necessary. While processing, all recorder
operations and functions including program recording will
not work until the process is finished. Also this process
erases all data stored on the DVD-RAM disc.
Notes
The physical format process may fail if executed to a dirty
DVD-RAM disc. Also, the disc may be difficult to record,
even if it finished. Before executing DVD-RAM physical
format process, be sure to confirm the disc is not dirty.
Clean it if necessary. If the disc has scratches or dust
beyond cleaner’s efficacy, do not execute DVD-RAM
physical format process on the disc.
The following DVD-RAM discs require physical formatting:
A disc which is not formatted correctly.
The disc which has errors during writing because of dirt
on the disc, and cannot be further recorded, or cannot
initialize normally.
You need to start physical formatting from the first step
again when you use a failed disc.
Physical formatting does not work if the disc contains a lot
of voids beyond the limitation of this recorder.
If an error occurs in physical formatting, “ERR-01” appears
in the front panel display. To turn off the message, press
DISPLAY button.
4) Press / to select “Start, then press
SELECT/ENTER.
5) Press
/ to select “Start, then press
SELECT/ENTER.
Initialization starts.
When initialization is completed, the setup window
disappears.
Format
0
DV D format
Start
Entire disc contents will be
erased if disc is formatted.
Proceed?
Cancel
%
18
DV D format
Format
DVD
Formatting
%
1) During stop, press SETUP.
2) Press
/ to select Management settings
then press SELECT/ENTER.
3) Press
/ to select DVD-RAM physical
format, then press SELECT/ENTER.
4) Press
/ to select Yes, then press SELECT/
ENTER to execute.
To cancel, select “No”, then press SELECT/ENTER
button.
5) Read the message, and press
/ to select
Yes or No, then press SELECT/ENTER.
Yes
No
Warning: It will take approximately
70 minutes to format a 4.7GB
DVD and all data will be erased.
Confirm t
hat timer programming isn’t
scheduled.
Proceed?
SETUP
Management settings
DVD-RAM physical format
Software version
DVD drive software
Genre setting
e.g.
e.g.
e.g.
e.g.
D-R4SU_Ope(US)p025-037 05.3.10, 4:33 PM29
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 130 131

Commentaires sur ces manuels

Pas de commentaire