Toshiba BDX2000KE Manuel d'utilisateur télécharger pdf (Page 41)

41EN

OTHERS

If the unit does not perform properly when operated as instructed in this manual, check the unit, consulting the

following checklist.

Troubleshooting

Problem Solution

No power - Check if the mains cable is properly connected.

-Unplug the mains cable once, and wait for 5-10 seconds and then plug it in again.

No sound or picture - Check if the connected TV is turned on.

- Check if the connections are made securely and correctly.

-Check whether the connected TV or other device supports HDCP. (This unit will not

output a video signal unless the other device supports HDCP.)

- Check whether the output format of this unit (HDMI FORMAT) matches the

supported input format of other connected device.

Distorted picture - Sometimes a small amount of picture distortion may appear.

This is not a malfunction.

- Connect this unit directly to the TV. If the composite audio / video cables are

connected to a VCR, pictures may be distorted due to the copy right protection

system.

Completely distorted picture

or black / white picture with

BD / DVD

-Make sure the disc is compatible with this unit.

No sound or distorted sound - Adjust the volume.

- Check if speakers are connected correctly.

- Check the HDMI connections.

- Check the settings in “Audio” menu.

Picture freezes momentarily

during playback

- Check the disc for fingerprints / scratches and clean with a soft cloth wiping from

centre to edge.

- Clean the disc.

Disc cannot be played back - Clean the disc.

-Ensure the disc label is facing up.

- Check if the disc is defective by trying another disc.

- Cancel the ratings control or change the control level.

-Insert a correct disc that can be played back on this unit.

SD card cannot be read - The format of the card does not match that accepted by this unit or the card is not

compatible.

No return to start-up screen

when disc is removed

-Reset this unit by turning it off, then on again.

The unit does not respond to

the remote control

-Aim the remote control directly at infrared sensor window on the front panel.

-Reduce the distance to infrared sensor window.

-Replace the batteries in the remote control.

-Re-insert the batteries with their polarities (+ / - signs) as indicated.

Buttons do not work or the

unit stops responding

-To completely reset the unit, press and hold [ON/STANDBY Q] on the front panel

for 10 seconds to shut down the unit or unplug the mains cable from the AC outlet

for 5-10 seconds.

The unit does not respond to

some operating commands

during playback

-Operations may not be permitted by the disc.

Refer to the instructions of the disc.

The unit cannot read BD /

DVD/ CD

-Dew condensation may form inside the unit. Do not use this unit for at least a few

hours until its inside gets dry.

-You are attempting to play back a disc other than one with one of the logos on

page 13.

-Wipe the dirt off the disc or replace the disc.

Angle does not switch - The angle cannot be switched for BD / DVD which do not contain multiple angles.

In some cases multiple angles are only recorded for specific scenes.

Playback does not start when

the title is selected

- Check the settings in “Parental” menu.

The password for rating level

has been forgotten

-Enter the default password “4737”, then your forgotten password will be cleared.

INTRODUCTION CONNECTIONS PLAYBACK FUNCTION SETUP OTHERS

E5RJ2ED_EN.book Page 41 Thursday, October 29, 2009 3:30 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 95 96

Commentaires sur ces manuels

Pas de commentaire

Toshiba BDX2000KE Manuel d'utilisateur Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de Blu-Ray Toshiba BDX2000KE