Toshiba E-STUDIO 210C Manuel d'utilisateur télécharger pdf (Page 145)

9-3

2. ADD PAPER SYMBOL

Adding Paper to the Cassettes

When the paper supply in the selected cassette or the large-capacity feeder (optional) runs out, the

cassette or large-capacity feeder shown on the display flashes, and the following message appears:

Add paper

Add paper as follows.

While pulling up the cassette grip, draw out the

cassette carefully until it comes to a stop.

Place paper in the cassette.

- Maximum number of sheets that can be set Page 2-4

- Fan the paper well before placing it in the cassette.

- Do not add paper above the line indicated on the guide.

- Do not use creased, folded, wrinkled or damp sheets of

paper.

Make sure that a gap of approx. 0.5 mm (less than 1 mm in

total) is left between the paper and the side guide. If there is

no gap, this would cause paper misfeeding.

Limit line

0.5mm 0.5mm

Side guide Side guide

Push the cassette straight in until it comes to a stop.

- Be sure to push the cassette fully in.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 195 196

Pas de commentaire

Toshiba E-STUDIO 210C Manuel d'utilisateur Page 145