Toshiba SD2010 Manuel d'utilisateur télécharger pdf (Page 26)

English

WARNING

Under no circumstances should you try to repair the DVD player yourself, as this will invalidate the

warranty. Do not open the DVD player as there is a risk of electric shock.

If a fault occurs, rst check the points listed below before taking the DVD player for repair. If you are unable

to remedy a problem by following these guides, consult your dealer or TOSHIBA for help.

Troubleshooting

Problem Solution

No power

No picture

Distorted picture

Picture clipped

Completely distorted picture or

black /white picture with DVD.

No sound / distorted sound

No audio at digital output

No sound and picture

Disc cannot be played

Picture freezes momentarily during playback

No return to start-up screen when disc is removed

The player does not respond to the Remote Control

Buttons do not work

-Check if the AC power cord is properly connected.

-Press the I/2ON/STANDBY on the front of the DVD player

to turn on the power.

-Refer to your TV' s manual for correct Video In channel

selection. Change the TV channel until you see the DVD

screen.

-Check if the TV is switched on.

-If the progressive scan feature is activated but the connected

TV does not support progressive signals or the cables are

not connected accordingly. See pages 12-13 for proper

progressive scan set up or deactivate the progressive scan

feature as follow:

1)PressOPEN/CLOSEontheDVDPlayer.

2)Whenthedisctrayisopened,pressnumberbutton＇1＇on

the remote control for a few seconds.

-Sometimes a small amount of picture distortion may

appear depending on the disc being played back. This is not

a malfunction.

-MaybecausedbyViewModeSetting(seepage20).Setto

Original for normal viewing.

-Connect DVD Player directly to the TV.

-Make sure the disc is compatible with the DVD player.

-Ensure that the DVD Player's setting is set to match that of

the disc and your TV.

-Adjust the volume.

-Check that the speakers are connected correctly.

-Check the digital connections.

-Check if your receiver can decode MPEG-2 or DTS and if not,

please make sure the digital output is set to PCM.

-Check if the audio format of the selected audio language

matches your receiver capabilities.

-Check that the cable is connected to the correct device (See

Connectingtotelevision).

-The DVD

R/RWmustbenalizedandinVideomode

format.

-Ensure the disc label is facing up.

-Check if the disc is defective by trying another disc.

-Wrong region code.

-Checkthediscforngerprint/scratchesandcleanwithasoft

cloth wiping from centre to edge.

-Reset the unit by switching the player off, then on again.

-Aim the Remote Control directly at the sensor on the front of

the player.

-Reduce the distance to the player.

-Replace the batteries in Remote Control.

-Re-insertthebatterieswiththeirpolarities(+/-signs)as

indicated.

-To completely reset the player, unplug the AC cord from AC

outlet for 5-10 seconds.

1 2 ... 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Toshiba SD2010 Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD Toshiba SD2010