Toshiba H9 Manuel d'utilisateur télécharger pdf (Page 47)

H9 ASD Installation and Operation Manual 39

Command Control Selections

The following is a listing with descriptions of the

Command Mode (

F003) selections (Program ⇒

Fundamental ⇒ Standard Mode Selection ⇒ Command

Mode Selection)

Settings:

0 — Terminal Block

Allows for Command control input via the

Terminal Board.

2 — EOI Keypad

This setting is used for EOI command control.

3 — RS485 (4-wire)

Use this setting if using a remotely-mounted EOI for command control. Connect the EOI to the

RJ45 connector of the Terminal Board.

4 — Communication Option Board

Use this setting if using the optional Communication Board for command control.

Frequency Control

Selections

The following is a listing with descriptions of the

Frequency Mode (

F004) selections (Program ⇒

Fundamental ⇒ Standard Mode Selection ⇒

Frequency Mode 1).

Settings:

1 — V/I

This selection is used when a 0 to 10-volt DC

analog input or a 0 – 20 mA DC current input

is used as the speed control input. Only one input signal type may be used at a time. Set SW301

to the desired signal type.

2 — RR

This selection is used for a 0 to 10-volt DC analog input signal.

3 — RX

This selection is used for a -10 to +10-volt DC analog input signal.

5 — EOI Keypad

This setting is used for EOI frequency control.

6 — RS485 (4-wire)

Use this setting if using a remotely-mounted EOI for frequency control. Connect the EOI to the

RJ45 connector of the Terminal Board.

7 — Communication Option Board

Use this setting if using the optional Communication Board for frequency control.

8 — RX2 Option (AI1)

This selection is used for a -10 to +10-volt DC analog input signal.

(Default)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 288 289

Commentaires sur ces manuels

Pas de commentaire

Toshiba H9 Manuel d'utilisateur Page 47

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Toshiba H9