Toshiba Tecra A4 (PTA40) Manuel d'utilisateur Page 141

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 204
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 140
User’s Manual 8-7
Optional Devices
Memory expansion
You can install additional memory in the computer’s memory module to
increase the amount of RAM.
Installing memory module
To install a memory module, make sure the computer is in boot mode then:
1. Turn the computer off in boot mode. Refer to the Turning off the power
section in Chapter 3.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Chapter 6, Power and Power-Up Modes.)
4. Remove one screw securing the memory module cover.
Only memory modules with the following parts numbers can be installed:
PA3311U-1M25
PA3312U-1M51
PA3313U-1M1G
If you use the computer for a long time, the memory modules will
become hot. In this case, let the memory modules cool to room
temperature before you replace them.
Do not try to install a memory module with the computer turned on or
turned off in Standby and Hibernation mode. You can damage the
computer and the memory module.
If you install a memory module that is not compatible with the
computer, a beep will sound when you turn on the power. If the module
is installed in slot A, there will be a long beep followed by a short beep.
If the module is in slot B, there will be a long beep followed by two short
beeps. In this case shut down the power and remove the incompatible
module.
Vue de la page 140
1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 203 204

Commentaires sur ces manuels

Pas de commentaire