Toshiba Satellite L730 Manuel d'utilisateur télécharger pdf (Page 46)

If the disc is not seated properly when the disc tray is closed, the disc might

be damaged. Also, the disc tray might not open fully when you press the

eject button.

Removing discs

To remove the disc, follow the steps as detailed below:

Do not press the eject button while the computer is accessing the media

drive. Wait for the optical disc drive indicator to go out before you open the

disc tray. Also, if the disc is spinning when you open the disc tray, wait for it

to stop before you remove it.

1. To pop the disc tray partially open, press the eject button. Gently pull

the disc tray out until it is fully opened.

When the disc tray pops open slightly, wait a moment to make sure the

disc has stopped spinning before pulling the disc tray fully open.

2. The disc extends slightly over the sides of the disc tray so you can

grasp it. Gently lift out the disc.

Push the center of the disc tray to close it. Press gently until it locks

into place.

How to remove disc when the disc tray will not open

Pressing the eject button will not open the disc tray when the computer’s

power is off. If the power is off, you can open the disc tray by inserting a

slender object (about 15 mm) such as a straightened paper clip into the

eject hole near the eject button.

Figure 3-7 Manual release with the eject hole

Φ1.0mm

1. Eject hole

Turn off the power before you use the eject hole. If the disc is spinning

when you open the disc tray, the disc could fly off the spindle and cause

injury.

L730/L735

User's Manual 3-

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 160 161

Pas de commentaire

Toshiba Satellite L730 Manuel d'utilisateur Page 46