Toshiba V.90 Manuel d'utilisateur télécharger pdf (Page 54)

AT Commands

AT command formats

+MS= <carrier>, <automode>, <0>, <max_rate>, <0>,

<max_rx_rate>

This command is used to set the various parameters described

below:

Example: +MS=V90C,1,0,0,0,0

This sets the modulation to be V.90 and the speed negotiations

to use automode. This is the modem default.

Example: +MS=V90C,1,0,0,0,45333

This will limit the maximum receive connect carrier speed to

45,333 bps in V.90 mode.

+MS?

This command returns the current +MS sub parameter settings.

+MS=?

This command returns a listing of all supported values for each

sub parameter. For the current modem driver, the response is the

following:

<carrier> A modem connect protocol string, such as

V.90 or 56K

<automode> 0 Disables automatic modulation negotiation

1 Enables automatic modulation negotiation

<max_rate> The maximum transmit rate. If set to 0, then

the max rate will be determined by the

modulation means selected in the <carrier>

and <automode> settings.

<max_rx_rate> Sets the fastest receive carrier speed. If set to

0, then max rate will be determined by the

modulation means selected in the <carrier>

and <automode> settings.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 101 102

Pas de commentaire

Toshiba V.90 Manuel d'utilisateur Page 54