Toshiba 27D47 Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 30
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
12
Caution:
Never throw batteries into a fi re.
Note:
Be sure to use AAA size batteries.
Dispose of batteries in a designated disposal
area.
Batteries should always be disposed of with
the environment in mind. Always dispose of
batteries in accordance with applicable laws
and regulations.
If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace batteries with new ones.
When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or
use new and used batteries in combination.
Always remove the batteries from the remote
control if they are dead or if the remote
control is not to be used for an extended
period of time. This will prevent battery acid
from leaking into the battery compartment.
Using the remote control
Installing the remote control batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two “AAA” size batteries. Match the + and – signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.
Learning about the remote control
POWER turns the TV on and off
CHANNEL NUMBERS allow direct access to channels (page 15)
RECALL displays status information on-screen (page 17)
SLEEP programs the TV to turn off at a set time (page 21)
MUTE turns off the sound (page 22)
CH / cycles through programmed channels (page 14)
VOLUME + / – adjusts the volume level
selects or adjusts on-screen menus (page 13)
MENU/ENTER allows access to programming menus, and sets
programmed menu information (page 13)
EXIT closes on-screen menus (page 13)
CH RTN (Channel Return) returns to the last viewed channel
(page 15)
PIC SIZE cycles through the three picture sizes—4:3, 16:9, ZOOM.
(page 19)
INPUT selects the audio/video input source (page 18)
ANALOG/DIGITAL selects analog/digital mode (page 14)
AUDIO selects the desired sound (page 22)
POWER
CHANNEL
NUMBERS
CH RTN
(Channel Return)
AUDIO
PIC SIZE
EXIT
VOLUME
+/-
MUTE
RECALL
SLEEP
CH /
MENU/ENTER
INPUT
ANALOG/
DIGITAL
Using the
remote control
30K-01(B)_EN.indb 1230K-01(B)_EN.indb 12 9/3/2550 16:40:599/3/2550 16:40:59
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Commentaires sur ces manuels

Pas de commentaire