Toshiba H1 SERIES TLCS-900 Manuel d'utilisateur Page 253

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 260
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 252
TMP92CM22
2007-02-16
92CM22-251
6. Port Section Equivalent Circuit Diagram
Reading the circuit diagram
Basically, the gate symbols written are the same as those used for the standard CMOS logic
IC [74HCXX] series.
The dedicated signal is described below.
STOP: This signal becomes active “1” when the halt mode setting register is set to the STOP
mode and the CPU executes the HALT instruction. When the drive enable bit <DRVE> is set
to “1”, however, STOP remains at “0”.
The input protection resistance ranges from several tens of ohms to several hundreds of
ohms.
Data bus (D0 to D7), P1 (D8 to D15), P4 (A0 to A7), P5 (A8 to A15), P6 (A16 to A23),
P76 (
WAIT ), PD2 (TB1OUT0), PD3 (TB1OUT1), PF6, and PF7
P90 (SCK), PC0 (TA0IN), PC1 (TA1OUT/INT1), PC3 (INT0), PC5 (TA3OUT/INT2), PC6
(TB0OUT/INT3), PD0 (INT4/TB1IN0), PD1 (INT5/TB1IN1), PF1 (RXD0), PF2 (SCLK0/
CTS0 ),
PF4 (RXD1), and PF5 (SCLK1/
CTS1 )
VCC
O
utput
d
ata
O
utput ena
bl
e
Stop
I
nput
d
ata
I/O
I
nput ena
bl
e
P-ch
N
-c
h
VCC
O
utput
d
ata
O
utput ena
bl
e
Stop
I
nput
d
ata
I/O
I
nput
enable
P-ch
N-ch
Vue de la page 252

Commentaires sur ces manuels

Pas de commentaire