Toshiba XLTR-200 Manuel d'utilisateur télécharger pdf (Page 11)

3. Installing the Gateway

The gateway’s installation procedure will vary slightly depending on the chosen

mounting method and the networks that will be used.

3.1 Mounting

3.1.1 Panel Mounting

The included standoff kit allows for panel mounting of the unit. The standoff kit

is comprised of four 1” aluminum male/female standoffs and four #6 lock

washers.

1. Remove one of the four cover standoff retention screws and its lock

washer from the bottom side of the unit. DO NOT dispose of this screw

and washer, as they will be used later to mount the unit to the panel.

2. Install one of the male/female standoffs and a #6 lock washer from the

standoff kit through the unit’s circuit board and into the bottom of the cover

standoff. Refer to Figure 1.

aluminum standoffs

lock washers

and screws

from step 1

gateway unit

anel

Figure 1: Standoff Kit Installation

3. Repeat steps 1 and 2 above to replace each of the three other cover

standoff retention screws.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 98 99

Pas de commentaire

Toshiba XLTR-200 Manuel d'utilisateur Page 11