Toshiba B-443 Manuel d'utilisateur télécharger pdf (Page 16)

EO1-33013

3. SET UP

3.1 Setting Up the Printer

1. Place the printer on a flat, secure surface.

2. Make sure the POWER switch is off.

3. Connect the printer to the computer mainframe with the provided RS-232C or

Centronics cable.

4. Plug the power cord into the power supply connector at the rear of the printer,

and then plug the power cord into a properly grounded receptable.

3.2 Loading Label and Tag Stock

1. Open the printer cover

2. Disengage the printer carriage by pulling the printer carriage release lever on

the left side of the platen.

3. Slide the label supply roll spindle through the core of a label roll and attach

the fixing tabs onto the spindle.

4. Place the label roll into the label roll mount. Feed the label under the carriage

and over the platen.

5. Adjust the label guide to fit the width of the media.

6. Engage the printer carriage.

7. Wind the label roll until it becomes adequately taut.

8. Close the printer cover and press the FEED button three or four times until the

green ON-LINE indicator illuminates.

9. When the printer is out of ribbon or media, the ON-LINE LED will not

illuminate and the ERR. LED will flash. Reload the ribbon or media without

turning off the printer power. Press the FEED button three or four times until

the ON-LINE LED illuminates. The printing job will be resumed without data

loss.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 34 35

Pas de commentaire

Toshiba B-443 Manuel d'utilisateur Page 16