Toshiba E-STUDIO900 Manuel d'utilisateur télécharger pdf (Page 163)

B070/B071 6-14 PTM

6.5.7 PAPER POSITIONING

Vertical Alignment

When the trailing edge of the copy passes the stapler tray entrance sensor [A], the

positioning roller solenoid [B] switches on long enough for the selected paper size

and pushes the positioning roller [C] onto the paper. The positioning roller and

alignment brush roller [D] rotate to push the paper and align the trailing edge of the

paper with the stack stopper [E].

The stapler transport motor (not shown in this diagram) drives rollers [C] and [D].

Horizontal alignment

When the Start key is pressed, the jogger motor [F] switches on and opens the

jogger fences 10 mm wider than the selected paper size.

When the leading edge of the sheet passes the staple unit entrance sensor, for the

initial alignment, the jogger motor switches on for the prescribed time and closes

the jogger fences 4 mm (2 mm closer to either side of the paper)

Next, the jogger motor switches on again for the prescribed time for the horizontal

alignment to close the jogger fences 6 mm (3 mm to the sides of the paper) for the

final alignment correction. The jogger motor switches on again and the fences

return to the wait position 10 mm wider than the selected paper size.

B468D014.WMF

[A]

[B]

[C]

[D]

[E]

[F]

[G]

[C]

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 223 224

Pas de commentaire

Toshiba E-STUDIO900 Manuel d'utilisateur Page 163