Toshiba E-STUDIO900 Manuel d'utilisateur télécharger pdf (Page 56)

PTM 2-31 B070/B071

2.4.2 LASER EXPOSURE MECHANISM

The LD unit consists of two 4-channel LDA’s (Laser Diode Arrays) and two collimating

lenses.

Each LDA produces 4 beams [A]. Each collimating lens [B] is a fixed lens, seated in a

V-groove and held in place by a spring and a screw.

Four beams from each LDA [C] pass through the collimating lenses, though the

apertures [D], then strike the polygonal mirror. Due to this multi-beam writing, the

polygonal mirror motor speed can be reduced, thus the noise generated by the

polygon mirror motor and the wear on the motor can be reduced.

Auto Power Control (APC)

A built-in photo diode detects the light emitted from the LD unit. When the photo diode

detects this light, it generates a signal and the feedback of this signal to the LD control

board is used to adjust the strength and amount of light in the laser beams.

NOTE: The laser diode array is assembled and adjusted in the factory, and does

not require physical position adjustment in the field.

LD drivers control the power output from the laser diodes.

(



Digital Processes > Printing > Laser Printing > Laser Diode Power Control)

NOTE: The reference levels are adjusted on the production line. Never touch the

variable resistors on the LD unit.

B070D102.WMF

[A]

[B]

[D]

[C]

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 223 224

Pas de commentaire

Toshiba E-STUDIO900 Manuel d'utilisateur Page 56